Replying to Operating a steam locomotive in trainz 2009
Posted 29 June 2012 - 06:23 PM
If you post a thread over on the Auran Forums, there are tons of people there who are more then willing to help you get started.
And for some shameless self-promotion, if your looking for Amtrak content, check out www.amtraktrainz.com
PS: also most people who have bug issues in TS9, have found that TS12 works much better. I personally use TS9 and have no issues with it.
PPS: oh also, some knowledge of how to run an actual steam engine is helpful...
Posted 29 June 2012 - 03:35 PM
Posted 24 September 2010 - 02:22 AM
Crescent ATN & TCL
Posted 24 September 2010 - 12:00 AM
How hard is it to operate a steam locomotive in trains railroad simulator 2009. I'm going along at over 88MPH and the regulators at 50 cutoff around 60 and they keep flashing yellow. I keep lowering the cutoff it still keeps flashing i increase the throttle they both keep flashing and it gets to the point the locomotive stalls. it pisses me off auran has to over-complicate things AND HOW THE HELL DO I ADD COAL. I can add water from a a valve in the locomotive but I can't bring the coal level up. The tender is full but the firebox is not. Half the knobs and switches are not labeled or just say ------- when you hover your mouse over them.Anyone got any tips.
Switch to MSTS, its old but its still the best. With all the add-ons out there you can find pretty much anything you want. Too bad MSTS2 got canceled twice,I think it would have done well...
Posted 11 September 2010 - 09:46 PM